![]() But you pay 2-3x more for the Genuine Honda parts and both options are likely to get you the same service life. I also did not hear the usual “warbling” sound that is common after installing the Aisin kits. I personally find the Honda timing belt to be better built and fits tighter than the Mitsuboshi belt in the Aisin kits. The customer specifically requested Genuine Honda parts. The side engine mount was replaced because it has started to crack and the mount was already being removed for the timing belt service. This is unfortunately quite common after 80-90K on the newer J-Series engines. Check that the battery cable plus post, goes to the starter, Minus post to a good ground, like the engine. Find the right fender liner, timing chain tensioner, or brake disc and pad kits for different model years. Good thing here at, you can find OE-grade Honda S2000 aftermarket parts at great prices. If the headlights do not dim or go out, then the battery is likely ok. Your Honda S2000’s performance will stay at its peak if you perform regular maintenance and replace any damaged parts right away. Check the battery like this: Turn on the headlights, then try to start the car. The hydraulic timing belt tensioner was dripping oil. Re: 2001 honda s2000 cranks but won't start. While the car was here I also replaced both air filters, all wiper inserts and performed a brake flush.Īs expected the timing belt, water pump and drive belt were in excellent condition. The valve adjustment was skipped since MAP voltage read. ![]() All parts were Genuine Honda except for the spark plugs which were NGK Laser Iridiums. The timing belt adjuster and idler pulley were reused. I replaced the timing belt, water pump, hydraulic tensioner, serpentine belt, side engine mount and spark plugs. I have maintained this car since its 3rd oil change. Sharing some photos from a Honda V6 timing belt service that was performed this week. Been messing with these old honda motors since they were,er,new.If cam chain wont quiet down with normal procedure,try this.before loosening 14 mm nut on adjuster,remove 10mm headed bolt in center,then find a couple ich long drywall or self tapping screw and put it in the hole yoy took the 10 mm headed screw out of.If you push gently and turn it clockwise,it should self thread.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |